Gameboy Macro Lens Guide

Gameboy Macro Lens Install

A simple guide on how to fit your Gameboy Macro Lens on a Nintendo DS Lite version of a Gameboy macro build.

What you’ll need:

Begin by

completely separating the digitizer from the LCD, Now take neoprene rubber & cut approx 69mm (or width of LCD). After which cut this piece straight down the middle to be left with two pieces 69mm x 5mm. These are your top and bottom pads

Gameboy Macro Lens Guide
Gameboy Macro Lens Guide

Stick the

top pad down exactly in line with the top bezel of the LCD. To gauge a reference for the bottom pad angle the LCD and you will see a black border, this is where you run your pad along the very top edge since the LCD starts within this border.

Gameboy Macro Lens Guide
Gameboy Macro Lens Guide

First cut

a strip to the length of 55mm, this will allow for extra. Now measure & cut two 3mm strips from your original cut, now you have two 55mm x 3mm pads. Apply pads along the edge of the LCD as a reference, when you get to the end cut the excess

Gameboy Macro Lens Guide
Gameboy Macro Lens Guide

Once your

system is back together, you can drop in the lens, be sure to make sure everything is dust free. I like to drop the lens in first so it’s preassembled for later.

Gameboy Macro Lens Guide
Gameboy Macro Lens Guide

Always take care when performing any modifications.
All illustrations/photos above are created and provided for your reference by Obirux.

Gameboy Macro

Leave a Reply

Your email address will not be published. Required fields are marked *

Close
Sign in
Close
Cart (0)

No products in the cart. No products in the cart.